There are no specific
requirements for recovery passwprd for the Cisco 2900, taking Cisco 2921 router and Cisco 2951 router for examples
The
steps:
1 Either switch off or shut
down the router.
2 Remove the compact flash
that is on the rear of the router. This image shows the rear of the 2951
router:
For more information, refer
to Back Panel Slots and Connectors on the Cisco 2921 and 2951 Routers.
3 Switch on the router.
4 Once the router is on
Rommon mode, reinsert the compact flash.
5 Type confreg 0x2142 at
the rommon 1> prompt in order to boot from Flash.
This step bypasses the
startup configuration where the passwords are stored.
6 Type reset at the rommon
2> prompt.
The router reboots, but
ignores the saved configuration.
7 Type no after each setup
question, or press Ctrl-C in order to skip the initial setup procedure.
8 Type enable at the
Router> prompt.
You are in enable mode and
should see the Router# prompt.
9 Type configure memory or
copy startup-config running-config in order to copy the nonvolatile RAM (NVRAM)
into memory.
Warning: Do not enter copy
running-config startup-config or write. These commands erase your startup
configuration.
10 Issue the show
running-config command.
The show running-config
command shows the configuration of the router. In this configuration, the
shutdown command appears under all interfaces, which indicates all interfaces
are currently shut down. In addition, the passwords (enable password, enable
secret, vty, and console passwords) are in either an encrypted or unencrypted
format. You can reuse unencrypted passwords. You must change encrypted
passwords to a new password.
11 Type configure terminal.
The hostname(config)#
prompt appears.
12 Type enable secret
<password> in order to change the enable secret password. For example:
hostname(config)#enable
secret cisco
13 Issue the no shutdown
command on every interface that you use.
If you issue a show ip
interface brief command, every interface that you want to use should display up
up.
14 Type config-register
<configuration_register_setting> . Where
<configuration_register_setting> is either the value you recorded in step
2 or 0x2102 . For example:
hostname(config)#config-register
0x2102
15 Press Ctrl-z or end in
order to leave the configuration mode.
The hostname# prompt
appears.
16 Type write memory or
copy running-config startup-config in order to commit the changes.
The Cisco 2951 price and Cisco 1921 price, please refer the below links:
| http://www.3anetwork.com/cisco-cisco2951/k9-price_p240.html |
| http://www.3anetwork.com/cisco-cisco1921-sec/k9-price_p210.html |
没有评论:
发表评论